[Cew27]

the temperatures will drop by about 4 degrees when the paste has burned in, you could lower the temps my fitting better fans to the rad

[alex]

there's 3 fans on the rad Cewy (see bottom pic).

Is the res mounted as high as possible? As this could be affecting the flow rate.

Also, is the triple rad cooling everything? (cpu, gpu(s), chipset etc)

If it's a quad i'd be tempted by another single 120mm rad after the cpu to cool the other components.

[brads900]

ive got 3 yate loons on the rad at the mo which i thought were quite good?
how high should the res? ive got it about 3 cm higher than top of res, the pa120.3 is cooling only the cpu and its dual core!? thats why i thought that new temp is still a bit high

thanks

[Cew27]

what are the fans set to i the bios, rpm i mean

[brads900]

ive got three fans on the rad going at 2109 rpm each

is tht low or high?

thanks

[Cew27]

thats quite high

[brads900]

so is that good or bad then? could that be causing the high temp?

tanks

[Cew27]

no its a good speed, im confused now as to what is causing the high temps
how much as5 did you apply and did you attach the water block corectly press down on the block and see if the temps lower

[brads900]

hey i put the amount on of a grain of rice which it said in a guide i read, pushing down doesnt make a diff at all, could it be the fluid im using feser one uv yellow stuff?

thanks

[Cew27]

i wouldnt think so , do you know if all the pumps are functioning correctly >