[Josh]

...case's? I want to cut a oval into the top of my computer case. What is the tool of choice to cut this neatly? Thank You. ~ Have A Fantastic Day.Josh

[divindavid13]

you know the drill bit you use to drill a door knob hole that would be a good choice

[Rik]

Well i have recently cut a load of holes in my case with a cheap jigsaw and it did a nice job.

[grush]

Dremell

[SocialWarfare]

Originally Posted by grush Dremell

Agreed Dremel ftw

[Rik]

A very good bit of advice i was given and have tested successfully is to use plenty of oil when cutting.

Pretty much any oil will do the job. It makes blades and cutting disks last much much longer and it makes the cutting much easier and quicker.

Be warned, it gets messy. To get the oil off the case once finished, washing up liquid and warm water does a great job. If its a steel case, remember to dry it as thoroughly as possible or the cut edges will begin to rust slightly.

The above makes drilling much easier and quicker too.

[DreamHazard]

Using a Dremmel to cut a starting hole, and a jig to cut the lines, and finishing off with a grinder on the Dremmel seems like a good idea, it's always worked for me...