[owen243]

Hey, im new Im Mike :)

I have my own custom Rig

C2D E6600 OC to 2.8Ghz
2Gb Kingston Ram
Geforce 7950GT

Right, i downloaded Ntune, and it told me about fully optimizing my system, stupid me says go along and selected GPU only to enhance.

I was reading along, it increased my PCI-E bus / AGP bus by 15% from 2500 to 2850Mhz. Then my system just restarted itself, well thats the problem, it doesn't boot back into Windows XP. I have loaded my system defaults from the Bios so it overrides the overclock to my RAM and CPU, but i cant find anything about the GPU> I tried going into safe mode, but it gets to loading A347bus.sys then reboots itself. I tried removing all cables to let clear of any charge in Mobo, but nothing. It wont load up to windows:(

Help

[Spencer2004]

here are my idears:
turn off the computer then remove the coin cell battery for 10 minutes then reinsert the battery and start your computer.

try repairing xp with the setup disk

remove your graphics card and use the onboard vga port.

try a fresh xp install on a spare partition or drive.

try a different graphics card.

[owen243]

Im on the part of the recovery at the moment on the XP Disk. In repair, it tells me to go to the drive i want to alter. Theres no C:, theres F

[Spencer2004]

well try f