[serverguy]

Originally Posted by Mooseknuckle

i do not have load line calibration

and i just tried to lower cpu voltage..it shows 1.31 v
and bumped fsb voltage +.2

orthos stopped within 10 seconds

In which case, you can probably leave it where it was than. The voltage is a little higher than I'd like, but its still in Intel specifications, so what gives.

If it fails, you can return it. And, you're temperatures seem very good, so there really is no problem.

[Mooseknuckle]

Well...now im am here

3.55ghz
1.344v
temps are fine

orthos does not stop but i ran intel burn on 1/2 memory stress because i cannot run the full and it only passed 1 of 5 tests....frustrating...any ideas

could it be because too much voltage or is it usually not enough voltage?

[serverguy]

Originally Posted by Mooseknuckle

Well...now im am here

3.55ghz
1.344v
temps are fine

orthos does not stop but i ran intel burn on 1/2 memory stress because i cannot run the full and it only passed 1 of 5 tests....frustrating...any ideas

could it be because too much voltage or is it usually not enough voltage?

Always not enough voltage.

Try running Orthos and see how long it is stable for. Or just do some gaming, what you normally use your PC for, and see if you get any crashes.

[Mooseknuckle]

ok i will....thanks server for all of you help through this...i appreciate it buddy.

[serverguy]

Originally Posted by Mooseknuckle

ok i will....thanks server for all of you help through this...i appreciate it buddy.

No problem.

Glad you're getting there now.

[Mooseknuckle]

I have done some gaming and used my pc as i usually would with no crashes so far....i think i am good where im at for now.