[coldest]

I want to ask you guys some questions about memory ram.

here is the information i found from my product specification.

maximum supported: 4 GB (2x2GB)
Speed supported: PC2-5300 MB/sec
type: 240 pin, DDR2 SDRAM

http://h10025.www1.hp.com/ewfrf/wc/d...roduct=3552366
above is the product specification website

now, i figure it's time for me to upgrade my pc so.... i want to buy a pair of 2x2GB ram... but i dont know which one i needed to buy....
even though it says speed supported is pc2 5300.... but can i still buy something like this: <4GB kit (2GBx2) / 240-pin DIMM / DDR2 PC2-6400 memory module> or <DDR2 2GB (2x1GB) PC2-6400 800MHz / Non-ECC CL5 / 240-pin / Unbuffered DIMM /



(well, i know that my vista 32 bit wont support all the 4GB...but is it bad for me?)

i found these two down here might be something that's good for me right now....
http://www.circuitcity.com/ssm/Kings...oductDetail.do

http://shop3.frys.com/product/5530560

which one is worth the money....well...or which one is better for my computer....

plz.... can anyone help me

[Bubba]

Carbon or Serverguy I think made the point to me that even though your Vista 32 can't see all 4 GB's it WILL see about 3.5 which is much better than two. i can't answer the rest, sorry.

[Carbon]

That last set is fine, as well as a good price.

Faster memory should work at the lower bus speed, so you should be OK with the speed being a little higher than your motherboard supports.

[coldest]

Originally Posted by Carbon

That last set is fine, as well as a good price.

Faster memory should work at the lower bus speed, so you should be OK with the speed being a little higher than your motherboard supports.

that's what i thought too....the faster one is cheaper than the one that match my computer too.....but do you have any more good suggestion?

[Carbon]

No, I'd grab it, if it wasn't the Fry's price i'd say go get it off NewEgg but that's about as cheap as you'd get it there.