[woodworks]

Alright my nc6000 will boot up to the HP splash screen with the bios setup access but when it leaves that screen the back light stays on but no image on the screen.

1.6ghz Pentium M
1.5gb Ram
60gb hard drive (i think, whatever is stock)

I have tried -

Unplugging the CMOS battery for 15 seconds

Removing the battery and power supply then holding the power button for 30-60 seconds.

Turning off the Intel speed step (was on auto)

Changing the outlet my power supply was plugged into.

No luck with any of that.

I was using it last night (Monday 10 PM) and today when I turned it on it was doing this.

*As soon as the screen stops displaying stuff there is a cursor flicker that lasts about half a second in the top left corner about 1/3 down the screen and then nothing*